The short version of GHS-R1a fits in a sentence. The long version — which is the one that helps — is below.
This page was last updated on 2025-12-02 and is reviewed periodically as new material appears.
Ipamorelin is a synthetic pentapeptide classified as a growth hormone secretagogue. Its sequence, Aib-His-D-2-Nal-D-Phe-Lys-NH2, combines three non-proteinogenic residues with a C-terminal amide. The N-terminal aminoisobutyric acid unit and the two aromatic D-amino acids distinguish it from peptides assembled only from standard L-amino acids. Its formula is C38H49N9O5, corresponding to an average mass near 711.9 Da. At neutral pH the molecule carries a net positive charge, a property that shapes its behaviour in chromatographic and electrophoretic systems.
The compound was developed at Novo Nordisk during the 1990s as part of a programme seeking secretagogues with improved selectivity. It was described in the peer-reviewed literature in 1998 alongside related pentapeptides from the same series. Investigators advanced it because it raised growth hormone output in animal models while leaving other pituitary hormones comparatively unaffected. The development code NNC 26-0161 appears in earlier reports, and ipamorelin later became the common designation in published work.
Human data remain limited and come mainly from small, short-term studies conducted decades ago. The peptide has not received approval as a medicine from major regulators, so current availability is largely as a research chemical. Reported effects on growth hormone pulsatility, appetite, and body composition should be read as preliminary, since few independent groups have replicated the original findings. Analytical characterization of research-grade material varies between suppliers, which complicates comparison across studies. Regulatory status also differs by country, and some jurisdictions classify it as a prescription-only or otherwise restricted item.
Ipamorelin is a synthetic pentapeptide that belongs to the growth hormone secretagogue class. It acts as an agonist at the ghrelin receptor, also called the growth hormone secretagogue receptor type 1a. The compound was designed in the 1990s during a search for agents that release growth hormone with fewer off-target hormonal effects than earlier secretagogues. It appears in the research literature under several sequence-based names. Material supplied for laboratory work is normally a lyophilized solid, and it is not marketed as an approved therapeutic in major jurisdictions.
The molecule contains five residues, including alpha-aminoisobutyric acid, D-2-naphthylalanine, and D-phenylalanine, and it ends in a lysine amide. Non-natural and D-configured residues make the chain less susceptible to common peptidases, which helps explain its resistance to rapid breakdown. Its molecular formula is C38H49N9O5, corresponding to a free-base mass near 711.9 daltons. The C-terminal amide removes a negative charge and is a recurring feature in receptor-active peptides of this family. These structural choices are usually discussed as the basis for its selectivity profile.
| Property | Value | Notes |
|---|---|---|
| Molecular formula | C38H49N9O5 | Pentapeptide with C-terminal amide |
| Average mass | Approximately 711.9 Da | Value derived from the formula |
| Appearance | White to off-white powder | Typically supplied as a lyophilised solid |
| Solubility | Soluble in water and aqueous acetonitrile | Dissolution aided by acidic diluents |
| Common synonyms | Ipamorelin; NNC 26-0161 | Code name used in early reports |
Storage recommendations for ipamorelin usually focus on temperature, moisture, and light. Lyophilized powder is typically held at or below minus twenty degrees Celsius in a desiccated container protected from light. Reconstituted solutions are often aliquoted and stored at minus eighty degrees Celsius to reduce repeated freeze-thaw cycles, which can promote aggregation or degradation. The optimal buffer and pH depend on the specific assay, and no single condition applies to every experimental context. Peptide stability should be assessed with time-point measurements rather than assumed from general handling rules.
In the scientific literature, ipamorelin appears mainly in preclinical studies, receptor binding assays, and reviews of growth hormone secretagogues. Authors often discuss its selectivity profile alongside limitations such as small sample sizes, short study durations, and differences between species. Some papers examine pharmacokinetics and clearance, but human data are limited and not sufficient to define general clinical effects. Regulatory discussion treats the compound as an investigational or research substance rather than an approved therapy in most jurisdictions. Open questions include oral bioavailability, long-term endocrine effects, and whether selectivity observed in animals persists in humans.
Peptides such as ipamorelin are subject to chemical and physical degradation. Hydrolysis of peptide bonds, oxidation of susceptible residues, and aggregation are common pathways that reduce purity over time. The rate of these processes depends on temperature, moisture, pH, and the number of freeze-thaw cycles a sample undergoes. Because the compound is typically handled as a lyophilized powder, controlling moisture during storage is a central concern. Degradation products can be detected with separation techniques that resolve the parent peptide from related impurities.
Lyophilized material is generally stored frozen and protected from light and moisture. Typical recommendations place dry powder at temperatures well below freezing, while reconstituted solutions are kept cold and used within a defined window. Repeated freezing and thawing should be avoided because it can promote aggregation and loss of material. The choice of solvent matters as well; compatibility with the intended diluent should be checked before preparation. These handling practices aim to preserve both the quantity and the integrity of the peptide.
Verification of identity and purity relies on analytical methods used across peptide chemistry. Reverse-phase high-performance liquid chromatography separates components by hydrophobicity and provides a purity estimate. Mass spectrometry confirms molecular mass and helps detect modifications. Together these techniques give complementary information about whether a sample matches its expected structure. Results depend on method parameters and reference standards, so reported purity values are meaningful only when the analytical conditions are stated. Consistency between laboratories requires comparable protocols and well-characterized reference materials.
Material supplied for research use is normally a white to off-white lyophilized powder. The solid is hygroscopic and is handled in a low-humidity environment to limit water uptake. Bulk quantities are frequently shipped in sealed vials under inert gas. Once reconstituted in water or a neutral buffer, the solution is less stable than the dry powder and is usually divided into single-use aliquots.
Long-term storage of the dry powder is typically at minus twenty degrees Celsius or lower, protected from light and moisture. Solutions are commonly kept frozen and thawed only once, because repeated freeze-thaw cycles can promote aggregation and loss of measurable peptide content. Buffers near neutral pH are preferred over strongly acidic or strongly basic conditions. Shipping at ambient temperature is acceptable for short periods when the powder remains sealed and desiccated.
Identity and purity are assessed by complementary methods rather than a single test. Reversed-phase high-performance liquid chromatography separates the peptide from related impurities and reports a percentage purity. Mass spectrometry, most often with electrospray ionization, confirms the expected molecular mass and detects sequence-related variants. Amino acid analysis can verify composition, while water content and residual counterion measurements support the mass balance of a batch. Stability studies under accelerated conditions are used to estimate shelf life, though such estimates carry uncertainty for long-term storage.
Ipamorelin 是一种合成五肽，在 20 世纪 90 年代被报道为生长激素促分泌剂。其结构基于胃饥饿素受体激动剂的设计思路，但并非天然激素。早期药理学研究显示，它可刺激垂体释放生长激素，而对应激激素轴的影响相对较小。该化合物常被用作研究生长激素调节通路的工具分子。
在机制层面，ipamorelin 与生长激素促分泌受体 1a 型结合，该受体也介导胃饥饿素的多种效应。受体激活后，细胞内信号促进生长激素从垂体前叶释放。由于对促肾上腺皮质激素和皮质醇的刺激较弱，它被视为选择性较高的促分泌剂。这种选择性在动物模型和少量人体研究中被观察到，但人体数据仍然有限。
Bernstein interpreted this as indicating that Engels was moving towards accepting parliamentary reformist and gradualist stances, but he ignored that Engels' stances were tactical as a response to the particular circumstances at that time and that Engels was still committed to revolutionary socialism. Engels was deeply distressed when he discovered that his introduction to a new edition of The Class Struggles in France had been edited by Bernstein and Karl Kautsky in a manner which left the impression that he had become a proponent of a peaceful road to socialism. On 1 April 1895, four months before his death, Engels responded to Kautsky:
A calcium gradient, with the lowest concentration in the stratum basale and increasing concentrations until the outer stratum granulosum, where it reaches its maximum. Calcium concentration in the stratum corneum is very high in part because those relatively dry cells are not able to dissolve the ions. Those elevations of extracellular calcium concentrations induces an increase in intracellular free calcium concentrations in keratinocytes. Part of that intracellular calcium increase comes from calcium released from intracellular stores and another part comes from transmembrane calcium influx, through both calcium-sensitive chloride channels and voltage-independent cation channels permeable to calcium. Moreover, it has been suggested that an extracellular calcium-sensing receptor (CaSR) also contributes to the rise in intracellular calcium concentration. Vitamin D3 (cholecalciferol) regulates keratinocyte proliferation and differentiation mostly by modulating calcium concentrations and regulating the expression of genes involved in keratinocyte differentiation. Keratinocytes are the only cells in the body with the entire vitamin D metabolic pathway from vitamin D production to catabolism and vitamin D receptor expression. Cathepsin E. TALE homeodomain transcription factors. Hydrocortisone. Since keratinocyte differentiation inhibits keratinocyte proliferation, factors that promote keratinocyte proliferation should be considered as preventing differentiation. These factors include:
=== Monomers and repeat units === The identity of the repeat units (monomer residues, also known as "mers") comprising a polymer is its first and most important attribute. Polymer nomenclature is generally based upon the type of monomer residues comprising the polymer. A polymer which contains only a single type of repeat unit is known as a homopolymer, while a polymer containing two or more types of repeat units is known as a copolymer. A terpolymer is a copolymer which contains three types of repeat units. Polystyrene is composed only of styrene-based repeat units, and is classified as a homopolymer. Polyethylene terephthalate, even though produced from two different monomers (ethylene glycol and terephthalic acid), is usually regarded as a homopolymer because only one type of repeat unit is formed. Ethylene-vinyl acetate contains more than one variety of repeat unit and is a copolymer. Some biological polymers are composed of a variety of different but structurally related monomer residues; for example, polynucleotides such as DNA are composed of four types of nucleotide subunits.
Sources: en.wikipedia.org
=== Thomson Medal Award (since 1985) === 2024 Jennifer S. Brodbelt 2022 Vicki Wysocki and Lidia Gall 2020 Alison E. Ashcroft 2014 Carol V. Robinson 2009 Catherine E. Costello and Catherine. C. Fenselau
== Medical uses == Selenium disulfide is sold as an antifungal agent in shampoos (such as Selsun Blue) for the treatment of dandruff and seborrheic dermatitis associated in the scalp with fungi of genus Malassezia. It is also used on the body to treat tinea versicolor (pityriasis versicolor), a type of fungal skin infection caused by a different species of Malassezia. A 2015 systematic review of topical treatments for seborrheic dermatitis of the scalp identified only a single randomized controlled trial evaluating selenium disulfide for the condition. It was a three-arm trial of 246 people with moderate to severe dandruff and compared treatment with 2% ketoconazole shampoo (n=97), 2.5% selenium disulfide shampoo (n=100), and placebo (shampoo base with no antiseborrheic agent) (n=49) for 29 days. The study found a 73% reduction in dandruff score with ketoconazole, a 67% reduction with selenium disulfide, and a 45% reduction with placebo. Based on the study, the systematic review concluded that selenium disulfide may be effective in the treatment of dandruff but that the available evidence is limited and overall evidence quality is low. It also found that while selenium disulfide has infrequent side effects, it seems to have more side effects than ketoconazole shampoo. Consequently, the review concluded that selenium disulfide should not be considered as a first-line therapy but instead should be used as an alternative treatment after other therapies like ketoconazole shampoo have proven not effective.
=== Remediation === Algae has shown selectivity for strontium in studies, where most plants used in bioremediation have not shown selectivity between calcium and strontium, often becoming saturated with calcium, which is greater in quantity and also present in nuclear waste. Researchers have looked at the bioaccumulation of strontium by Scenedesmus spinosus (algae) in simulated wastewater. The study claims a highly selective biosorption capacity for strontium of S. spinosus, suggesting that it may be appropriate for use in treating nuclear wastewater. A study of the pond alga Closterium moniliferum using non-radioactive strontium found that varying the ratio of barium to strontium in water improved strontium selectivity.
power reactors are intended to produce heat for nuclear power, either as part of a generating station or a local power system such as a nuclear submarine. research reactors are intended to produce neutrons and/or activate radioactive sources for scientific, medical, engineering, or other research purposes. breeder reactors are intended to produce nuclear fuels in bulk from more abundant isotopes. The better known fast breeder reactor makes 239Pu (a nuclear fuel) from the naturally very abundant 238U (not a nuclear fuel). Thermal breeder reactors previously tested using 232Th to breed the fissile isotope 233U (thorium fuel cycle) continue to be studied and developed. While, in principle, all fission reactors can act in all three capacities, in practice the tasks lead to conflicting engineering goals and most reactors have been built with only one of the above tasks in mind. (There are several early counter-examples, such as the Hanford N reactor, now decommissioned). As of 2019, the 448 nuclear power plants worldwide provided a capacity of 398 GWE, with about 85% being light-water cooled reactors such as pressurized water reactors or boiling water reactors. Energy from fission is transmitted through conduction or convection to the nuclear reactor coolant, then to a heat exchanger, and the resultant generated steam is used to drive a turbine or generator.
Sources: en.wikipedia.org
It is a synthetic five-amino-acid peptide that acts as a growth hormone secretagogue. Three of its residues are non-standard amino acids, and the chain ends in an amide rather than a free acid. The molecule is small enough that it can be characterised by routine peptide analytical techniques.
It has not received marketing approval as a medicine in the United States or the European Union. Supplied material is generally described and handled as a research chemical. Regulatory treatment varies by jurisdiction, and some countries restrict growth hormone secretagogues under sports or medicines legislation.
Earlier secretagogues were associated with broader hormonal responses, including measurable changes in cortisol and prolactin. Reports on this peptide describe a narrower profile in which growth hormone release is the most prominent effect. The observation is influential because it shapes how the compound is compared with other members of the same receptor family.
It has not been approved as a therapeutic by major regulators, and the human trial record is small and dated. Material available today is mostly sold as a research chemical for laboratory use. Approval and restriction status varies by country.